2nd Semester Week 4: 02/27 - 03/06

This week

- Had two group meeting to complete all of Eric's to-do list for Superway as a whole. We also meet to start and complete our senior project presentation.

- Had 3D printed a motor casing for fitment testing

- Made changes to original CAD drawing and sent updates to Central Shop for manufacturing.

- Made changes to shaft design due to a change with Guideway Team


Comments

Post a Comment

Popular posts from this blog

Week 9: 10/17 - 10/24

This week: -> Got together as a team to work on presentation -> Also meet up with other teams to make sure that all information is up-to-date and the same. -> We are currently in contact with XOFO motors about a recommended motor, since MAC Motor has been unresponsive. -> Ran kinematic simulations on the motor XOFO recommended. -> Calculated outputs of our motor to make sure we have enough output to move bogie Since we have decided to go with another motor: -> Drew preliminary CAD drawings our shaft -> Ran FEA on our designed shaft -> Got an invoice for 6 motors without controller -> Updated Gnatt chart: motors are currently delayed but on schedule for everything else. -> Spoke with Dr. Furman about reducing the number of motors needed in order to save money Next Week: -> Continue CAD design of shaft and motor casing -> Keep in contact with XOFO, MAC Motor, QS, and TDCM about motor -> Purchase Motors (4)
Read more

Week 7: 10/03 - 10/10

On October 03, 2018: -> Following up with the projects, we met with our mentor to narrow down the motor that we are going to use for Makers Faire. Specification: - Motor type:  M12500 - 3A by MAC motor - Brushless DC hub motor - Rated Power: 600 - 1000 [W] - Rated Voltage: 36 [V] / 48 [V] - Speed: 2000 - 4000 [RPM] We are currently keeping in contact with MAC motor for more detail information, such as: - Customizing planetary gearbox - Exact dimensions of the motor - Possibly customizing shaft design and length -> We spoke with the control team to discuss KBL controller for controlling the motor speed. KBL controllers are a device that sees voltage and converts that into motor speed. -> We spoke with our mentor about our concern about the motor overheating while running at 2 miles per hour for few minutes during Makers Faire. We believed that in order for the bogie to run at 2 miles per hour, our motor has to run at a low RPM. However, according to the specs
Read more

2nd Semester Week 13: 5/1-5/8

The main focus this week for the motor team was to work with bogie interaction team to integrate the motors, motor's wheels, and axle onto the drive bogie. During this integration process, both teams ran into quite a bit of an issue with manufacturing the hole on the drive bogie for the axle to be fitted into. It was originally planned so that hole sizes of approximately 1.010 inches were to be water jet cut into the four supporting plates of the drive bogie; however, bogie interaction team wasn't able to have those holes made during the water jet process. This means that we had to use a drill press to create the 1-inch holes. The problem with drilling the one-inch holes manually is that it would be quite difficult to have all four holes on the four plates to align properly for the axle to slide through. To resolve the issue, we filed and milled out the holes to a greater size for the axle to be fitted into. To further secure the axle, we incorporated face mounted lock colla
Read more